>>> Ten Steps to Make Bathroom Clean and New

In home decoration, because the bathroom has the largest number of water pipes, it is also most prone to leaking pipes. A master Wang who was engaged in renovations called the reporter on the 4th to suggest that the public should design the bathroom when the house is renovated.

Pipe installing

Pipeline works according to the requirements of the households and design requirements. After the completion of the test pressure should be carried out, inspection can be carried out before the other decoration works.

The quality of selected pipes and fittings shall comply with the requirements of national standards. All thick-walled pipes shall be used, and thin-walled pipes shall be strictly prohibited. The installation of the pipeline must be horizontal and vertical, the drainage pipeline is unblocked, and the installation should be laid out reasonably, as close as possible to the wall, and the position of the valve should be set correctly to facilitate maintenance and use. After the water pressure test, there must be no water seepage or water leakage at the connections of all joints, valves and pipes. After the installation is complete, it should be fixed in time.

Water heater installation

The installation of the water heater should be upright, valves should be installed at the inlet and inlet, and copper ball valves should be used for the gas valve. All pipelines should be rust proofed after pressure test.

Hot water pipelines should be equipped with thermal insulation to prevent the surface of water pipes from forming water.

Sanitary ware construction

Toilet bowls and bathtubs shall be installed after the top of the brush and paint wall is scraped and smoothed with grout. The installation of sinks and washbasins shall be done after the tiles are tiled on the wall. Sanitary ware and water inlet pipes and sewage pipes must be tightly connected, and no water seepage or water leakage may occur. When the sanitary ware and drainage pipes are connected, the pipe diameter and slope of the drainage branch pipes shall meet the design requirements.

The washbasin, sink, and shower faucet should be installed properly. Hot and cold water fittings should be installed under the washbasin. Cold water should be on the right, hot water should be on the left, and the leading position should be upright.

The installation position of the toilet and the water tank should be accurate and closely connected with the wall surface and the ground. Installed sanitary ware should take protective measures.

Drain plugs and floor drains are installed flat and firm, below the drainage surface, without leakage. After the bathroom mirror is installed, apply a glass seal around the gap.

Experience on bathroom decoration design glass home decoration housing bathroom glass tile glass door bathroom tile bathroom door bathroom washbasin bathroom design bathroom waterproof bathroom leaking tile adhesive

3 Wire Trunking Linear Lights

Why choose to use the trunking?

The trunking will be pre-laid with wires before leaving factory, and there is no need to lay other wires during installation, It can save labor costs. Linear Trunking Light can realize seamless splicing, and various shapes can be spliced through L/T/X connectors, as shown below


X$5`JS5X%0CK[6SYWCPBD5V

The length of the trunking is generally 1 meter, 1.5 meters and 2 meters. 3 Wire trunking linear lights can only achieve basic lighting. If you need to add emergency, sensor or dimming functions, you can choose 5 wires/7 wires/8 wires/11 wires.

Retail Lighting Solution,Trunking Lighting,Light Trunking System,Commercial Lighting

SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com

Posted on