First, check the fire pool into the fire pump, spray pump valve is always open Second, the fire pump 1 , Kai pump program: ( 1 ) Open the inlet and outlet valves of the pump ( 2 ) Press the pump start button to start the pump ( 3 ) Check the pump inlet and outlet pressure, motor and pump body temperature, noise ( 4 ) Make a record 2 , stop the pump program: ( 1 ) Press the stop pump button to stop the pump ( 2 ) Close the inlet and outlet valve ( 3 ) Make records; 3 , fire pump control cabinet is in the "automatic" position, press the fire hydrant alarm button, linkage cabinet sound and light alarm, while the fire pump starts automatically. 4 , fire pump control cabinet is in the "manual" position, press the start button to "manually" start the fire pump. 5. During the test, close the system valve and open the drain valve. After the test is completed, reset it again. Check whether the control cabinet handle is in the “automatic†position. Third, the regulator pump 1 , Kai pump program: ( 1 ) Open the inlet and outlet valves of the pump ( 2 ) Press the pump start button to start the pump ( 3 ) Check the pump inlet and outlet pressure, motor and pump body temperature, noise ( 4 ) Make a record 2 , stop the pump program: ( 1 ) Press the stop pump button to stop the pump ( 2 ) Make a record ( 3 ) Place the control box handle in the automatic position. 3 , spray pump control cabinet in the "automatic" position, when the sprinkler burst, the linkage cabinet sound and light alarm, while the spray pump starts automatically. 4 , spray pump control cabinet in the "manual" position, press the start button to "manually" start the spray pump. 5. During the test, close the system valve and open the drain valve. After the test is completed, reset it again. Check whether the control cabinet handle is in the “automatic†position. Fourth, maintenance 1 , daily inspection of fire water sources, pumps, valves, alarm valve groups, etc., and should ensure that the system is in a trouble-free state, recorded in detail in the duty records 2. Check the fire pool and air pressure water supply equipment once a month to ensure that the water level, water quality, and air pressure of the fire fighting water supply are under normal pressure. In cold season, take good insulation measures to ensure that no part of the water storage equipment is allowed to freeze. 3 , fire pump starts running once a month, and to ensure that it is in a fault-free state 4. All control valves on the system should be open or specified. When the system is being overhauled, records should be carefully made, and the valves in the system should be checked and opened and closed every month. 5 , fire pump room maintenance workers repair and maintenance of equipment as required, and maintenance records 6. After the firefighting equipment is repaired, it must be restored to its original state, and the original equipment and lines must not be changed at will. The information in this article comes from the Internet and was reorganized and edited by China Rescue Equipment Network. The Emergency Sensor Light is specially designed for ceiling Mounted emergency lighting and with Microwave Sensor. from 12inch 18W to 18inch 36W. Dimmable lighting, Waterproof and Dustproof avialable. Widely using for Office and Household. Automatically light at once when buildings main power outage. It is more than 3 hours emergency time. When Main power is on, it use as an normal sensor lighting Led Emergency Sensor Light,Emergency Light Sensor,Microwave Sensor Emergency Light,Emergency Sensor Light Foshan Nai An Lighting Electric Co.,ltd , https://www.articalight.com
News Related Keywords: No tags.