The TV wall is familiar to all of us. In order to make the living room more beautiful, many families have been designed for a long time. However, when I installed the TV wall, I found that it was not very good with the style at home. There are many situations. In order not to let ourselves have such troubles, we need to learn these in advance. Today, Xiaobian will take a look at the installation of the TV wall method and the installation of the TV wall. TV wall installation method 1. Use a suitable wall before hanging the TV, including the wall is not close to the kitchen and bathroom, the wall with low moisture, the wall is the main axis of the house. When installing a flat-panel TV, it is easy to avoid when installing Damage to the surface of the TV, so a protective film is placed on the TV screen. 2. It can also be found on the general TV package. Damage caused on the screen or on small circuits can easily cause a dead pixel on the TV. Therefore, it needs to be carefully installed and handled gently. First install the fixed bracket on the wall and install the TV bracket in the pre-set position. To ensure the safety and stability of the bracket, compare the position and center of gravity of the TV. 3. Reinforce the bracket, the metal components must be welded firmly or the edges must be rust-proofed. Be careful to leave some room for the TV to dissipate heat. After installing the TV, adjust it again, gently install the TV, adjust it slightly, and the horizontalness of the left and right sides is similar. The translation error of the whole position of the flat-panel TV installation should be less than 1cm, and the inclination error of the left and right sides is less than 1 degree. Be careful to move gently when adjusting. Compare the adjustment level over long distances. 4. Connect the relevant wiring. Including audio wiring, etc., pay attention to distinguish between left and right and positive and negative. When connecting the speaker cable, pay attention to the positive and negative polarity of the speaker cable to avoid reverse the left and right channel sounds. The power line should be installed with an air switch, etc. The protective device should not be free to change the length of the power cable and signal cable. Installing TV wall precautions 1. Bedroom TV background wall width should be appropriate: the bedroom is often smaller than the living room, so the bedroom TV background wall should be designed with full consideration of width and area. Because the eye drive and the TV are 3.5 times the size of the TV, don't make the TV wall too thick, which will make the bedroom experience small. 2. The living room TV background wall considers the distance of the sofa: When decorating the home, first determine the position of the sofa, then determine the position of the TV, and then determine the shape of the TV background wall by the size of the TV. 3. Preserve enough panel position on the wall: If your home is decorated with a wall-mounted TV set, leave the wall with a pre-embedded pendant such as a sufficient socket. 4. Consider the light from the TV and the ceiling: The TV wall generally echoes the partial ceiling of the top surface. There are generally lights on the ceiling. Therefore, it is necessary to consider the wall shape and the light, and consider not to illuminate the TV. Avoid eye fatigue when watching the show. The above is Xiaobian's introduction to the TV wall method and the installation of the TV wall. The notice is here. If you need to install the TV wall later, you can refer to these simple methods for installation, which will definitely bring us a Very nice decorative effect. For more information, please stay tuned to the renovation home. Brass Gas Ball Valves,Brass Angle Gas Ball Valve,1 Brass Ball Valves,2 Brass Ball Valve AS-SUR INDUSTRIAL VALVE CO., LTD. , https://www.assur-valve.com
