Diamond Hole Saw,Diamond Tip Hole Saw,Glass Hole Saw Drill Bit,Diamond Hole Saw Drill Bit Danyang Yongshun Tools Co.,Ltd , https://www.china-drill-bit.com
For pico projectors, the more common uses are nothing more than handhelds, desktop placements, and support frames. Although the hand-held mode is still relatively rare during actual use, it does not rule out the use of special circumstances. It is suggested that the hand-held device should not be used for long periods of time. This has an impact on heat dissipation.
When the desktop is placed and used, it is necessary to pay attention to whether the micro projector is highlighted, because the micro projector is reduced in design due to its small size, especially the cooling fan. When the highlight projector is placed on the desktop for a long time, it will greatly affect the life of its use. As the current mainstream high brightness products in addition to the side design of the cooling outlet, there will be under the air inlet or cooling outlet, which requires the user to use, it must try to keep the mini projector from the desktop a certain distance, it is recommended It is best to use a stand to use. If not, Xiao Bian made a move for everyone. To find the four bottle caps and put them in one corner, the effect was still very effective. Also, do not place the projector on a sofa, mat, or other soft surface when placing it. This will prevent the projector from overheating.
When using the support frame, the micro projector does not have the problem of heat dissipation, but it should be noted that it is better to adjust the required size of the projection screen when using. After confirming, it is better to use the remote control to operate the menu. The control keys of the body are not recommended because the universally-available stand stability is not very good. Therefore, once the force is too great, the shape of the screen will be changed and the screen will be changed again. It is a waste of time, and it is often used as a depreciation product.
Micro-projector is different from ordinary consumer electronics products. It wants to power on and turn off, and it will take a while to cool off. For the projector, this is also the most taboo. If you do not get a good heat dissipation, it will directly affect the life of the bulb, especially if the micro projector, the user must avoid switching off, do not immediately unplug the power, wait a few minutes to pull, specific The operating instructions will also have details.
After use, remember to cover the lens dust cover, do not invade the dust. Without such a good habit, once the dust attached to the lens is too much, it will affect the clarity of the output content. In addition, it will also affect the life of the micro projector. After being used for a period of time, it is necessary to regularly clean up dust accumulated on the air vents of the air conditioner. If necessary, use a vacuum cleaner to gently inhale it. The air vent should be avoided. If there is a problem with use, do not disassemble it yourself. You need to seek the help of a manufacturer or professional service personnel.
With the micro-projector gradually entering the era of high-definition brightness, it is a step closer to popularization. As an emerging product of the projection industry, many consumers are not fully aware of this little thing. Inevitably it will cause some damage to the product during use, which will shorten the life of the micro projector. Therefore, for the user, it is still necessary to understand some maintenance tips. Next, the small editors talked about the small common sense that people need to pay attention to in the process of use.