>>>On the decoration of the group teach you choose the toilet The pit distance is generally 220mm, 300mm, 305mm, 400mm, 420mm Tools and materials to install the toilet: flange mounting screws, slotted screwdriver, toilet water inlet angle valve, flange, wrench, hand saw, tape measure, spirit level, wax ring. installation steps: 1 Drive two flange mounting screws into the concrete floor and insert the floor flange. After the floor drain flange is installed on the floor drain pipe, the centerline distance from the back wall (finished wall surface) should be the same as the pit distance of the toilet seat you purchased, generally 220mm, 305mm, 400mm, 420mm, etc. Note: If replacing the old toilet, be sure to turn off the water before moving the old toilet. 2 Place the toilet on a soft surface to avoid scratching the surface glaze. Place a wax ring firmly around the toilet water outlet. Also, check that the toilet bowl's return trap is unobstructed. 3 Carefully place the toilet in position and allow the flange mounting screws to pass through the base hole of the toilet bowl. Use a slight and rocking motion to press the toilet until the toilet is level. It is recommended that someone should help when installing a one-piece toilet. 4 Use a plastic washer (see if the washer has a directional mark, place it in the direction indicated, facing up if it is marked "up") and tighten the nut; use a hand saw to cut off the excess screw length and fasten the nut in place . 5 Installing a toilet water tank (does not require a one-piece toilet) Place the sponge gasket on the outlet at the bottom of the tank and lower the tank onto the toilet; insert the rubber gasket into the tank screw and through the tank, align the hole in the toilet (cross-sectional illustration); insert the gasket and The nut is used to stabilize the water tank. Tighten the nuts alternately to the left and right to stabilize the tank. Tighten the nuts alternately left and right until the tank is firmly mounted on the toilet bowl. 6 Connect the water supply pipe to the tank inlet valve. Then carefully bend the water supply line and connect it to the toilet inlet angle valve. The connection of the fastening angle valve and the tank inlet valve. 7 In the water tank, insert the return pipe into the overflow pipe with the positioning clip (if available). 8 Slowly open the toilet water inlet valve and check the watertight connection. Bathroom toilet cement Stainless Steel Handrail Fittings Stainless Steel Handrail Fittings,Wall Mounted Vertical Handrail Brackets,Stainless Steel Railing Fittings,Stairs Stainless Steel Handrail Foshan Maysky Stainless Steel Co., Limited , https://www.mayskysteel.com
9 Adjust the water level adjustment nut to bring the tank water to the specified water level. Adjust the flow adjustment nut so that the water in the tank fills for 30 to 60 seconds.
10 Install the toilet seat cover as instructed by the manufacturer.