Extrusion is a metal forming process , in which billet is passed through a die , to get required cross section of component .
Non cutting process
Production of Fixed cross section
Types of extrusion process
Direct extrusion process
Indirect extrusion process
Impact extrusion process
Hydrostatic extrusion process
Tube extrusion process
Cobalt Alloy Hot Extrusion Dies Extrusion Die,Hot Extrusion Dies,Cobalt Alloy Extruder Die,Extrusion Die Head Mold Shenyang Top New Material Co., Ltd. , http://www.topcobalt.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge> Bearing work view Bearing work view
After the bearing device is installed, it should be inspected; the bearing device should be in place; the rotation is sensitive; there is no stuck image; if the bearing device is not properly; the bearing temperature will rise and become damaged, and even the bearing jam and cracking will cause major accidents. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Bearing application and storage (1) When the bearing is used; adhere to the cleanliness of the surrounding environment; do not stick to the hand sweat and dirt. The rules are used by the personnel who understand the bearing; the unique requirements are careful injury, indentation, damage, etc. To ensure the bearing The performance of the application; should be based on the operating specifications of the equipment; time to protect, protect and repair the bearing; the content includes monitoring the operating conditions, make up the lubricant, time to open the view.
(2) Bearings should not be stored directly on the ground (more than 30cm above the ground); avoid direct light and cold walls. To avoid rust; store in an environment with a temperature of about 20 ° C and a humidity of less than 65%; the bearings are placed in acid In the air; simple rust, discoloration; use gloves, kapok yarn to scrub the bearings, shafts, shells; waste into the bearing and cooperation is the cause of abnormalities; therefore demand attention.
Recommend to friends comments close window Bearing related knowledge The limit speed of the bearing is used to repair the technical standard of the centrifugal pump bearing. After the IKO joint bearing device is installed, the work test is focused on the composition of the problematic spherical roller bearing and the chemical composition and data characteristics of the bearing data.
This article links to http://
Please indicate China Bearing Network http://
Previous: NTN Bearing Information and the Cause of Overheating Next: The Gas Smooth Bearing
Source: Bearing network time: 2013-09-08