How to correctly choose the peristaltic pump how to correctly select the peristaltic pump:
Sealand is a trustworthy manufacturer of Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter, ATEX, IECEx & CE approved.
The installation is as follows.
1. Installation Steps
valve location into consideration;
a) Sensor stays away from mechanical vibration source, for example, pump. Use flexible
pipe to connect meter with pipeline if inevitable. The housing of meter must be standalone,
out of touch with any other device. There must be 3 times the size of sensor between 2
sensors if there are many flow meters on the same pipeline, to avoid resonance.
b) Do not install sensor on pipeline that easily expands with hot and contracts with cold,
especially near expansion joint, which leads to a worse stability.
c) Sensor stays away from industrial electromagnetic field, such as large generator and
transformer, better 5m at least. Such device influences the performance of drive coil and
pickoffs. Make sure magnetic field intensity less than 400A/m.
d) Sensor shall be installed on lower pipeline, to be easily full of fluid.
f) Build a sunshade if the meter is under direct solar radiation.
g) Keep the meter from corrosive liquid.
First, choose a peristaltic pump product that is right for you. It is not a simple job. You need to consider the following factors:
1. Choose independent and complete peristaltic pump products or OEM peristaltic pump products, depending on your application;
2. In OEM peristaltic pump products, what voltage, installation method, flow rate, cost, etc. are provided by you is a key factor;
Second, choose what peristaltic pump brand, you need to consider the following three factors:
1. Whether the supplier is a regular peristaltic pump production brand enterprise, which directly affects your worries;
2, the strength of peristaltic pump manufacturers, including research and development strength, production scale, quality control system, after-sales service system, etc.;
3, the price factor is also very important, not the cheaper the better, the regular manufacturer price is transparent.
a) Choose correct installation site, taking installation area, pipeline, transmitter location &
b) Install the meter according to direction mark on sensor;
c) Install the sensor & transmitter on pipeline;
d) Connect transmitter & sensor with 9-pin cable;
e) Start.
e) Make sure Ex-mark meet application requirements if in hazardous area.
Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter
Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com