The whole land is made into a seedbed with a leeward sun, a deep and fertile soil, and well-drained sandy soil. Apply 2,000-3,000 kilograms of fertilizer per acre, deep-plow the fine stalks, spray the generals to protect the trees, reduce the source of the bacteria, and then do the sputum after the whole land, the width is 1 meter. Seed treatment of pepper shells is hard, oily, waxy, impervious to water, germination is more difficult, degreasing treatment before sowing. Soak the seeds in an alkali aqueous solution (1 kg of seed with 25 g of alkali powder, add water to submerge the seeds), remove the empty seed, soak for 2 days, rinse off the oil on the seed coat, remove and dry the spray. The lipid film was sown after 800 times. Ditching can be sown from the end of autumn until the soil is frozen. Each ditch is 4 to 5 rows, the ditch is 5 cm deep, and the seeding amount per mu is 10 to 12 kg. After sowing, cover 2~3cm thick fine soil cover, and then spray a new high-fat film 800 times liquid to protect the water-proof evaporation, sun-proof and drought-resistant, heat-preserving anti-freeze, anti-soil layering, suffocation and isolation of pests and diseases, and increase the emergence rate. . In the early spring, when the defrosting is carried out in the spring of the next spring, it is suppressed once, so that the seeds are in close contact with the soil, so as to facilitate the water absorption of the seeds. Look at the nursery, do not let people enter the trample. Watering in the early spring will be watering. After a few days of watering, keep it moist and keep it moist. (果丽红)
MT-1H is an automatic hot mounting press machine, Which is suitable for curing different material, such as epoxy resin, phenolic poWder,acrylic poWder, etc.
Automatic Mounting Machine,Mounting Machine In Metallurgy,Automatic Flexo Plate Mounter,Metallurgical Lab Equipment TROJAN (Suzhou) Technology Co., Ltd. , https://www.troolymaterial.com
Total 1 | <First <Prev 1 Next> Last> |
share to:
Modular design of mounting unit to meet customer`s specific needs;
Sliding closure with automatic open/close;
7-inch touch screen with max. 20 commonly procedures;
Pre-heating and per-press furcction to meet the specific mounting reguirement of different material;
Real-time display the temperature and pressure curve during curing;
Individual control of heating/pressing/cooling for every unit.
7-inch HMI,Friendly and simple user interface
desigh;
Automatic water cooling, with three modes of
cooling rate;
Sliding closure design for easy opening and
closing mould assembly easy to change;
Fully hydraulic pressure.