Epoxy flooring is used for functional flooring from the beginning: if it is anti-corrosion, wear-resistant, non-slip, developed to a common general industrial floor; in addition to functional requirements, it also has a decorative effect. On the basis of the wide application of industrial floors, with the continuous improvement of people's living standards, they have been promoted and applied in home decorating. Floor paint has become one of the fastest growing industries in China and has attracted everyone’s attention. It can achieve industrial production like cement products. The prospects are even more impressive! Applicable to a variety of venues, such as: factory buildings, computer rooms, warehouses, laboratories, wards, operating rooms, workshops, etc. Here we will introduce tennis floor floor construction and performance characteristics of the process tennis courts. Tennis court floor performance characteristics: 1. The use of paint free of solvents, non-volatile substances, so no pollution, in line with environmental protection requirements 2. The surface is smooth, smooth, beautiful and can get mirror effect 3. Good resistance to acids, alkalis, chemicals, solvents, oils, etc. 4 according to the specific circumstances of the thickness of the choice between 1-5mm 5. Durability of anti-static effect, not affected by time, temperature, humidity 6. Strong adhesion, wear resistance, scratch resistance, high strength. Tennis court floor Tennis court floor selection points First, mechanical performance requirements The following three main areas: 1. Abrasion resistance: What vehicles will the floor use when walking; 2. Pressure resistance: how much load the floor will bear during use; 3. Impact resistance: whether the impact will cause the floor to peel off Second, the chemical performance requirements Mainly consider the following two aspects: 1. Acid and alkali resistance: The type and concentration of corrosive chemicals used during use; 2. Solvent resistance: The type of solvent and contact time when used. Third, the floor position According to the position of the floor on the ground floor or on the ground floor, determine whether moisture treatment is needed or choose a special moisture-proof floor. Fourth, the basic situation 1. Base strength: General requirements for compressive strength ≥ 20Mpa; 2. Flatness: whether it needs to be repaired with epoxy mortar; 3. Self-leveling treatment is generally required before construction of the ground. V. Security requirements If the floor is in an oily environment or on a slope, you need to choose a non-slip floor. If you are at a gas station or a special place such as an oil depot, you need to choose between anti-static and explosion-proof. Construction process: (1) Clean up debris on the floor and polish it to keep it clean. (2) Primer with epoxy primer to enhance ground strength and adhesion. (3) Repair holes at the holes. (4) Full scraped epoxy-silica mortar twice (5) Full scrape epoxy putty (6) Grind the whole and clean the dust. (7) Brush epoxy paint again. (8) Apply epoxy self-leveling paint again to ensure that the surface layer is smooth, bright and smooth. Summary: Information on the performance characteristics of the tennis court floor and the construction of the tennis court floor was introduced here. I hope this article will be helpful to everyone. If you still have something you don't understand, you can leave a message to Xiaobian at the bottom. We will answer your questions as soon as possible. Floor Disc Springs are conical annular discs that bear axial in and out, generally with constant disc thickness and uniform load distribution on the inner edge of the upper surface and the outer edge of the lower edge. Disc springs are usually made of spring steel and can withstand static loads, non-alternating loads, dynamic loads, and can meet strict fatigue life and loading loss requirements Compression Spring,Compression Disc Spring,Disc Spring Washer,Compression Spring Washers Ningbo FLK Technology Co., Ltd. , https://www.flk-global.com
