Home lighting is selected according to different needs in the home. The installation of the same home lighting depends on different types. Chandeliers, ceiling lamps, wall lamps, etc. all have their own installation methods. The following introduces several common lamps. Installation requirements and methods. (I) Installation requirements 1 Lamps and fittings should be complete, and there should be no defects such as mechanical damage, deformation, paint peeling, and lampshade cracking. 2 The bearing capacity of the fixture on the wall ceiling of the installed fixture should match the weight of the fixture. 3 The hanging lamp should be equipped with a hanging box, and only one set of hanging lamp can be installed in each hanging box. The surface of the pendant lamp must be well insulated and no joints are allowed. The conductor cross-section must not be less than 0.4 square millimetres. The wiring in the terminal box should take measures to prevent the lamp head from being forced to drop the lamp. Lamps with a weight of more than 1 kilogram should be equipped with a hanging chain. When the weight of a chandelier lamp exceeds 3 kilograms, it should be fixed by a pre-embedded hook or bolt. The light of the hanging chain light should not be pulled, and the light line should be forked together with the hanging chain. 4 The ceiling lamps with incandescent lamps as light sources shall not be directly installed on the combustible components; the lamps shall not be closely attached to the lamp housing; when the distance between the lamp and the insulating table is less than 5 mm, insulation measures shall be taken between the lamps and the insulating table. The power of the incandescent lamp must not exceed the maximum power allowed by the luminaire. 5 When a fluorescent lamp is used as a light source, the ballast shall be installed on the phase line. In the lamp, there should be a case where the lamp leg should be prevented from falling out of the housing, and there should be a margin in the lamp box. The frame of the giant lamp is parallel to the decoration of the ceiling, and the lamp is The frame should be close to the ceiling. 6 Screw terminal phase wire should be connected to the terminal of the center contact, and the neutral wire should be connected to the screw terminal. The insulating cover of the lamp head should be complete, no damage and leakage. 7 The hook of a fixed lantern should not be smaller than the lamp hook, and the minimum diameter of the lamp should not be less than 6 mm. Lamps and lanterns to buy lamps and lanterns to install lamps brand decorative lighting home paint bed headboard wall lamp Particle Board Co., Ltd. , http://www.nswoodflooring.com
è´»çº Lighting Minor sofa
1 2 Next> Total 2 Page
Page to page