It is not difficult to install a shower, but many people don't know how much the shower is installed. In fact, master the shower installation height, you can also install the shower. How to properly install the shower head for the shower installation height. In general, the ceiling height of the bathroom is 2.2-2.4 meters. The height of the shower column of the fixed height can be 90-100 cm from the ground, and the height of the shower head with adjustable height is 60-80 cm. Shower, Bathtub Faucet When you have purchased a shower, bathtub, or wall faucet, you can choose the right level to bury the water pipe. The spacing between the hot and cold water pipes must be 15 cm. Before installation, you must not forget to rinse the water pipe to avoid excessive water quality and damage to the faucet. If the elbow between the faucet and the wall joint is too long, cut off a portion of the 4 points and remember that the 6 points connected to the faucet cannot be tangled. . Concealed shower, bathtub faucet After purchasing a concealed faucet, it is generally necessary to pre-bury the faucet of the faucet in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be buried. The plastic protective cover of the valve plug should not be easily removed when it is buried, so as not to damage the valve core in the case of cement and other chores. In addition, when pre-burying the valve core, you should also pay attention to the up and down and left and right directions of the valve core to avoid the valve core being buried. Before installing the thermostat faucet, please check if the water pipe is left hot and right cold. Remember not to connect the hot and cold water pipes incorrectly, so as to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat. Showers When you install the shower and bath faucet, don't forget to filter the filter inside the shower. When installing a shower, the water pressure must not be too high, generally 1-3 cm, not more than 5 kg. If the water is high, the water flow limiter in the faucet spool can also be opened to reduce the water pressure, and the water saving effect can also be achieved. How to properly install the shower Step 1: First prepare the tools needed to install the shower faucet: drill, screwdriver, ruler, hammer. Step 2: Look at the instructions, then measure the size with a tape measure, determine where the shower faucet is installed and the mounting height of the shower faucet, and mark it. Step 3: Place the shower holder in the marked position and use a pencil to mark the specific location where you need to punch. Step 4: Make a hole in the wall based on the location you just made. Step 5: Hammer the expansion sleeve of the expansion screw into the hole and screw the circular bottom cover of the accessory to the wall. Step 6: Install the shower pole on the wall, first stabilize the upper fixing point, and then fix the position below. Step 7: After making sure that the inner corner screws of the above fixed points are all screwed in, carefully adjust them. Step 8: Tighten the hose of the shower, install and install the hand shower, and the entire installation step ends.
Non-pressurized
Solar Water Heater is a cost-effective system for residential hot water
application. this system is designed according to thermosiphon principle and
operating with proportion difference between cold and hot water. The water
heated by Vacuum Tubes is held in the stainless steel storage tank where the
insulation preserves the heat.
The
thermosiphon solar water heater uses the sun to heat the working fluid (mostly
water) in the vacuum tubes. The Solar Collector absorbs solar radiation, and
converts the sunlight to heat and transfer it to the water. The heated water
naturally rises through the solar collector into the water tank where the
cooler water at the bottom of the tank is forced out and descends to the bottom
of the collector (thermosiphon circulation). The circulation will be
interrupted when there is no solar radiation.
Advantages
and benefits
- Low
cost in maintenance and repair requirements.
- Short
amortization rate
- Economic
customized solar water heating solution
Performance
characteristics
- Stainless
steel inner and outer tank, highest water tank quality for coastal areas
Non-Pressurized Solar Water Heater Solar Panel Heater,Non Pressurized Solar Water Heater,Non Pressure Type Water Heater,Solar Water Heater 300L Linuo Ritter International Co.,Ltd , https://www.lnrtsolarenergy.com
-
Cost effective solar water heating solution
- Long operating life time over 10 years
- Higher energy yield and low heat loss due to the high vacuum of the
evacuated tubes and PU insulation harmless to ozonosphere
- High-quality stainless steel in the inner tank to continuously maintain
a good water quality.