Our daily life is inseparable from such things as toilets, it is a necessity in the bathroom. But after using the toilet for a long time, some troublesome situations will inevitably occur. So, what should I do if the toilet inlet valve does not enter the water ? How to disassemble the toilet inlet valve? Get to know. 1. The reason why the toilet inlet valve does not enter the water Before you understand how to deal with the toilet inlet valve is no longer filled, we must first know what causes the toilet inlet valve does not enter the water. Under normal circumstances, the buoy cargo float of the inlet valve is stuck or there are foreign objects inside the inlet valve, etc., which will cause the inlet valve of the toilet to not enter the water. In addition, there is a problem inside the water inlet valve, which is also likely to cause the water inlet valve not to enter. How to solve it? Then look down. 2. The solution of the toilet inlet valve not entering the water a. If it is checked that the buoy cargo float of the inlet valve is stuck, then the buoy (float) can be pulled up and down by hand to enable the inlet valve to enter the water normally. b. If it is caused by a foreign body inside the inlet valve, it is very difficult for the average user to repair it alone. Therefore, it is recommended to ask a professional person to repair or replace it. c. If it is found that there is a problem with the inlet valve itself, maintenance will be difficult. The specific analysis is as follows: First, close the water inlet valve, and then take out the water stopper cover at the part of the water, and clean the adhesion of foreign objects or replace the water stopper cover. Secondly, use a cross screwdriver to remove the broken shaped nut, replace it with a new shaped nut, and tighten it. Then, regularly cleaning the inlet valve can also reduce the occurrence of such situations. 3. How to disassemble the toilet inlet valve Step 1: Remove the blue integral water inlet valve. Step 2: Take off the "hat" of the inlet valve. Step 3: Remove the part of the white linking point attached to the aconite. Step 4: Use small pliers to turn counterclockwise to separate the two parts, and then install it clockwise. The fifth step: even the key part of the water pipe. Step 6: Lift the float, the water will be stopped, it proves to be repaired. Editor's conclusion: The above is an introduction to how to disassemble the toilet inlet valve , what are the reasons for the toilet inlet valve not entering the water , and solutions. I hope this article will help you. If you still have any questions, you can continue to follow our website. What, the decoration still uses his own money? ! The Qi family is decorated in installments, with an ultra-low annual interest rate of 3.55% and a maximum loan of 1 million. Apply now to enjoy the discount If you are interested in brand cooperation, content cooperation, and advertising of this website, please send an email to :. The toilet inlet valve does not enter the water
PA6 rod's main properties includes high mechanical strength, stiffness, hardness, toughness, good aging resistance, good mechanical damping ability, good sliding properties, excellent wear resistance, good machining performance, when used for precise and effective control, no creeping phenomenon, anti-wear Good performance and good dimensional stability.
PA6 rod, nylon rod, nylon pa6 rod, plastic pa6 rod, nylon rod plastic Shenzhen Anheda Plastic Products Co.,Ltd , https://www.ahdplastic.com
